Mr Surfacer 500 Spray 100ml by Mr Hobby GUZ-B506 B506

Mr Surfacer 500 Spray 100ml by Mr Hobby GUZ-B506 B506

$6.99

Out of stock

Email when stock available

SKU: 4973028540604 Category:

Description

A versatile filling, smoothing, and texturing agent.

Product code 500/1000/1200, is the thicknesses:

Mr. Surfacer 500 – this coating is useful for filling in bumps, dents, scratches, for removing bubbles, texturing and finishing bases. It is suitable for large-scale repairs and can be used as soluble putty.

Mr. Surfacer 1000 contains finer granules than Mr. Surface 500.

Mr. Surfacer 1200 -An even finer form.  Thinned down, may be airbrushed.  Test before using. About the same consistency as many acrylic model paints

Size: 40ml

GSI Creos ( Formerly Gunze Sangyo )

Item: GUZ-B506

Contents subject to change. 

This must ship via ground due to Transport of Dangerous Goods Regulations.  As a result, spray paints are not returnable or refundable.
Canada – can’t be shipped to some locations
USA – can’t be shipped Via Air – Parcel Select service only.

We are a certified shipper of Hazardous Goods

Customer Reviews

Based on 4 reviews
100%
(4)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
S
Sascha Uncia
Good for smoothing rough surfaces

Works well for smoothing surface defects, such as when working with 3D prints. Does however require a fair amount of product spread over a few coats.

Attached is a picture of a large FDM-printed base printed with 0.12mm layers. The stones are a shallow-angled surface, a worst case scenario for prominent layer lines on top surfaces.

It required a few coats with Surfacer 500, sanding, another two coats, more sanding, coating with surfacer 1000, and more sanding. A lot of work but good results.

This stuff sands well and is quite durable. It also sticks perfectly to the plastic I was using.

User picture
S
S.U.
Good stuff so far

Just tried this out on a bare PLA print and it did a good job filling in fine layer lines (0.12 - 0.16 mm Layers). I tried scratching it off with my fingernail after a few hours and it held strong, no flaking.

Sands well. Quite impressed. Make sure to use a respirator for application and sanding.

F
Frank Smart
Spray-able Surface Product

Excellent to work with. As a scratch builder I often have fine blemishes in my models that are slow to fill. A few coats of this fast drying material soon does that and it sands out extremely fast and smooth. Highly recommend it.

A
Andrew Monus
Excellent

Superb results with Mr.Surfacer . Used for an ultra smooth finish on a mould plug on my R/C DLG.

Related products

fr_CAFrench
fr_CAFrench